503-427-0140
9am-5pm, Monday-Friday
HOW TO INSTALL
TOOLS NEEDED
Compatible with: Mercedes Sprinter Van 144/170
Year 2007 and up

  INTRODUCTION  

INSTALLATION OVERVIEW

This guide will show you how to prepare your van for a RUV kit install. This tutorial focuses on what is required to prep a Sprinter 144 (2007+) crew van. The general process is the same for 170 wheelbase vans as well Cargo van configurations. Preparation involves removing the headliner, pillar trim pieces as well as seats and factory wall paneling

What do I need?

  • Pry tools of various sizes

  • Cordless Screw Driver

  • Torx bits for factory connections in pillar and seat bases

  • A buddy to help with the tear-down

  IMPORTANT  

Summary of the Steps (1-2 hours)

 

  1. Workspace and Tool Cart

  2. Place a “loose parts” storage box on the dash

  3. Disconnect battery by unplugging ground (negative) connection under right side of driver footwell

  4. Remove Front Seats (4 bolts, remove yellow seat heater connectors)

  5. Remove B Pillar covers

  6. Remove Cockpit Headliner

  7. Remove Walls and Ceiling

  8. Remove Slider Door Panel

  9. Remove Rear Door Panels

  PURCHASE THE KIT  

VAN PREPARATIONS

  • TOOLS
  • INTERIORS PANELS
  • ELECTRICAL PREP